Hf100 Oxygen Torch Height Controller for CNC Oxy-Fuel Cutting Machine

1)Quick Detail

proper configuration of the torch lifter mechanism is an important factor for establishing the accuracy of your  cutting system,be sure that:

1. gear reduction is selected on the torch lifter so that the maximum suspension speed does not exceed 3000mm/min,if higher accuracy is required,maximum suspension speed should be set to 1500mm/min

 2. gears ,racks and spindles have minimal backlash

3. oversizing is avoided.the mass of moving parts,including armature inertia must as small as possible.motors with low nominal RPM are perferred

4.  only DC motors with the following ratings are used:

motor ratings: DC MOTOR

motor voltage: DC24V

max curret: 6A

2)Pre-installation considerations

1.check to confirm that you have all of the required parts

2.fimiliarize yourself with the parts of the HF100 

3.check to be sure that the torch lifter motors you are using with the HF100 are within the acceptable range

4.review the instructions for configuring the lifter mechanics in section 1.6 of manual

3) Applications:

1. Designed for CNC flame cutting machine

2. High induction sensitivity, run smooth and stable

3. Set upper and lower limit switch inside, reduce the loss of motor, prolong the service life.

4. Used for cutting torch auto height  control of cutting machine, it is suitable for vast majority of imported or domestic models of machine.